MF 282 Motorised Expansion System - Drive kit for 4 backgrounds consisting of 4 motorised expansion drivers with power supply
The Manfrotto 282 Motorised EXPAN is Drive Kit for 4 Backgrounds consists of four motorized Expan Drives with power supply and cabled remote control. Also includes a set of two universal holders for 4 backgrounds, which may be hung from wall or ceiling. The total load capacity of this kit is 100kg.
The Manfrotto 282 Motorised EXPAN is new Expan system provides a convenient and simple way to operate and adjust your studio backgrounds, using remote controlled motors that suspend, raise and lower up to 10 canvas or paper backgrounds at a time.
Alternatively, use the manual roll up/down features for different positioning and fine adjustment. And when you've finished shooting, tidying the backgrounds out of harm's way is a touch of a button.
Backgrounds are quickly interchanged in their holders and you can automatically set each background's high and low positions, then smoothly and easily roll from one to the other with a press of a button.
Key Features:
- Heavy duty motor to allows operation of heavy backgrounds (up to 26 lbs each).
- Smooth operation with cardan-type clutch.
- Equipped with hall-effect electronic position sensors, enable positioning precision down to 1/3 of a turn.
- Backgrounds are quickly interchanged in their holders and you can automatically set each background's high and low positions, then smoothly and easily roll from one to the other with a press of a button.
- Remote controller and control box are both programmable for operation on one of seven different channels - if two control box systems are used in the same room, they can be set to different channels to avoid interference. In this case, it is not possible to control both main control boxes with one remote IR controller.
- Communication protocol IRUP - Infra Red over UPSEC Protocol.
- Advanced IR receiver is very sensitive to remote controller signal but extremely disruption-proof.
Manfrotto 282 Motorised EXPAN details:
- Supplied in sets (one set = 1 passive roller and 1 active motor drive).
- Heavy duty motor to allow operation of heavy backgrounds (up to 26 lbs)
- Smooth operation thanks to cardan - type clutch
- Equipped with hall-effect electronic position sensors, enable positioning precision down to 1/3 of a turn
- Very easy to install just plug in jacks
- Cable to Main Control Unit 1.5 meter length
- Load Capacity 100 kg
